Furnace repair, install and service should be done by a certified contractor. It is important to have your furnace serviced and maintained annually to ensure safety and efficiency. Local building code specify the type of furnace that can be install, restriction on the placement of furnace and minimum duct requirements. Code also address special considerations and restrictions associated with the installation of a furnace. Codes may even regulate the installation of burners to convert furnaces from oil or propane to gas.
A heating system can be classified into two common ways, mainly by heat source and heat distribution. Most of these systems produce heat by burning oil, gas, propane or the use of an electric element. A gas furnace heats your home by burning natural gas or propane to provide heat, which is distributed by the blower motor throughout your home delivering warm air to each room. Furnace are generally categories as, Natural draft, Forced-air or Condensing. Most Furnaces today are mainly Single-Stage, Two Stage or Modulating.
Single-Stage Furnace: This is a standard system which has only one stage of heating when running, during a call for operation. The output of these units are constant which means, these systems will use more energy comparing to other model furnace.
Two-Stage Furnace: A two-stage unit can produce two different levels of heating, allowing it to adjust heat output to meet the demand require. When less heat is required, a two-stage furnace will operates on the first stage, which uses less energy and thereby increasing efficiency hence lowering cost. Furnace would automatically turns on second stage heating and finish heating process.
Modulating Furnace: These are design with solid-state integrated controls which acts as the brain of the system and can modulate their heat output form 40 to 100%. Once there is a call for heat from the thermostat, the controls on the circuit board will initiate a sequence of events. This then direct the system to supply heat to the building efficiently.
Basic Components of a Furnace
- Indoor Blower fan motor
- Combustion blower motor
- Heat exchanger
- Gas valves
- Pressure switch
- Circuit board
A gas furnace should also be serviced at least once a year, whether it’s in the spring or in the fall. Annual maintenance, including a thorough examination and cleaning of the parts that commonly malfunction, such as air filter, fan motor, pilot light, and heat exchanger, can usually prevent major problems. Example:
This is one of the most dangerous situation that can happen as a result of not servicing your furnace regularly. When the heat exchanger cracks, your furnace could leak carbon monoxide inside your home, in large quantities. This could be very dangerous to your family’s health. Safety inspection on furnace heat exchanger should be done before each cold season begins by checking for cracks or water leak marks. Deadly gases can easily seep through cracks and into your home, this will result in illness and even death.
NOTE: Technical Safety BC mandates that individual who performs furnace repair, install and service comply with local guidelines.
- Furnace repair should be perform by a gas certified individual. This not only could be costly when having unqualified individual working on your system but could also violates home insurance policy.
- Furnace install must be done by register contractors. Contractors are also require to pull gas permits
- Furnace service should not be done by individual without the proper license.
We Service, Repair, Install and Maintain all brands:
- American Standard
- Lower Mainland
- New Westminster
- Pitt Meadows
- Coquitlam, Surrey
- White Rock
- Fraser Valley area.